Pringles Can Straw Dispenser (for big printers)

prusaprinters

<p>Good straw dispensers are expensive and most break easily. So I decided to make one out of a Pringles can.<br/> The main bar is a good 245mm long so you will need a large prints, it may fit your printer if you turn it 45 degrees.<br/> I printed on a TAZ 4 with ABS and used Acetone to glue up all the parts.</p> <h3> Instructions</h3> <p>Simply print and assemble as shown. I printed the knob and main rod with very sparse infill (10%) and the bottom and top plates solid.<br/> If you print with ABS you can use acetone to glue together (PLA use Super glue or epoxy).<br/> The rod fits snugly into the base and the cap and knob. Glue to base first. Then slide cap on down a ways, glue knob onto end, then add glue to the bottom edge of the knob and slid the lid up to it (knob and cap should be touching).</p> Category: Kitchen & Dining