PRIMO water cooler probe receptacle

thingiverse

Replacement Part for PRIMO Model #900127. Since the replacement part is not available on PRIMO's website, I had to look elsewhere for an alternative solution. My sister's water cooler probe broke where the four tabs at the bottom latch of the unit were damaged, three out of the four were broken. Pictures show the original part with broken tabs and the newly created part. Remove the lower disk ring seal and the shaft seal from the old probe to make way for the new one. Place the seals on the newly printed probe which was acetone-coated to ensure a smooth finish. Printer: Lulzbot AO-101, Calibration still needs fine-tuning Design Software: DesignSpark Mechanical Slice Engine: Cura / Matter Control Layer Height: 0.12mm Infill: 100% Supports Needed: Two-millimeter spacing, one millimeter away from the object in a grid pattern. Print Time: Seven hours