Primo hopper replacement lid

thingiverse

This is a direct replacement for the Primo hopper lid that typically cracks over time from the stock version. The new lid will snap shut just like the original one, secured by its spring mechanism. Print Settings Printer: FlashForge Creator Pro Rafts: Doesn't matter at this point. Supports: Yes is okay. Resolution: A minimum of .2mm is required. Infill Percentage: You should aim for 40-50%. Notes: MakerBot desktop will sometimes automatically add supports to the flat section of the lid during printing, leading to a potential print fail if you're not careful. It's possible to circumvent this issue in two ways: Print with no raft and added supports - use glue stick instead, then make sure to clear out the hole for the pin using a drill bit; or simply print without supports, but do include a raft in your settings.