PRIME W 3950 3D printing modification shell

thingiverse

这是一个改装用的3D打印鼠标外壳文件 This is a modified 3D printed mouse shell file 你需要拆卸一只DA V3P才能完成改装 You need to disassemble a DA V3P to complete the modification 除了打印件外，你还需要这些 1.圆头十字自攻螺丝M1.7*6（用于固定上下壳和底盘） 2.扁平头十字螺丝M1.6*4.5*4.5头（用于固定PCB及安装按键） 3.特氟龙膜胶带 0.13mm厚度(用于调整空键程及按键盖晃动) 4.按键支柱金属耐磨贴 4*5*0.12mm 5.LDT1.5mm直径导光柱 Besides the printed copies, you also need these 1. Round head cross tapping screw M1.7 * 6 (used to fix the upper and lower shells and chassis) 2. Flat head cross screw M1.6 * 4.5 * 4.5 head (used to fix PCB and install buttons) 3. Teflon film tape with a thickness of 0.13mm (used to adjust empty key travel and key cover shaking) 4. Key pillar metal wear-resistant sticker 4 * 5 * 0.12mm 5. LDT1.5mm diameter light guide column 打印材料建议使用PA12尼龙或者光敏树脂，注意文件中零件壁厚只有1mm，应当注意那些需要拆除支撑的打印方式对零件本身的影响 It is recommended to use PA12 nylon or photosensitive resin as the printing material. Please note that the wall thickness of the parts in the document is only 1mm, and pay attention to the impact of printing methods that require removal of supports on the parts themselves 有一些组合打印件，有的可以降低3D打印报价，有的是自带支撑加强打印和运输的可靠性 There are some combinations of 3D prints, some can reduce the 3D printing quotation, and some come with built-in support to enhance the reliability of printing and transportation