Pressure Washer Nozzle Storage

Pressure Washer Nozzle Storage

thingiverse

NOTE: This design requires 5 gaskets or the nozzles will not be held properly. This is a holder for pressure washer nozzles. It holds 5 nozzles: * 0 degree - Red * 15 degree - Orange * 25 degree - Green * 40 degree - White * 65 degree - Black You can obviously put any nozzle in any position but these are the 5 most common nozzles and the values are displayed on the holder. The holes are sized for a gasket that is * inner diameter (ID): ½" * outer diameter (OD) 13/16" * thickness: 9/32" * groove diameter 5/8" * groove width 1/16" I found these at Ace Hardware in the USA, part number 55057-G. They were $0.79 each and is the most expensive part of the holder since you need 5. The cost of the print was under $0.25. The gasket should fit with a bit of clearance that allows the holder to swing without binding. This is necessary because when you insert/remove the nozzle, the gasket needs a bit of room to deform. The sizes and colors are raised in the model and can be colored for visibility. I used a white metallic maker. There is also a small hole at one end to allow a carabiner or string to attach this to the pressure washer so it will be readily available when you use your washer.

Download Model from thingiverse

With this file you will be able to print Pressure Washer Nozzle Storage with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Pressure Washer Nozzle Storage.