Pressure gauge pod

thingiverse

I created this pressure gauge housing for my child without checking Thingiverse first, only to realize later that someone else had already published it! It consists of two parts: the cylindrical body and a rear cover with a slot for cables. To ensure a snug fit, I applied a small amount of hot glue to the back cover pins. I'm considering adding a miniature screw in the future to make it more secure. The OpenSCAD code is included here, but since this was a one-time design, I didn't bother to parameterize or optimize it. If you decide to modify the code, good luck with that! The gauge body has a diameter of 52mm and is held in place by the U bracket, which presses against a lip inside the cylindrical part. To install the gauge, simply insert it from the front and the bracket through the back.