Press-Fit Filament Guide, Cleaner & Cable management for the CR-10 with MK8 Aluminium Extruder

thingiverse

I've taken the liberty of remixing [chito's](https://www.thingiverse.com/chito) outstanding [filament guide/cleaner/runout sensor](https://www.thingiverse.com/thing:2513373), opting instead to secure it firmly in place using a press-on fitting - this eliminates the need for z-axis rod guide screws, which I prefer not to use due to their intended loose fit.\r\n\r\nTo accommodate this design change, you may need to reposition any lock washers under the guide screws so they're slightly off-center towards the z-axis rod.\r\n\r\nFurthermore, the wire loom holder has been extended for added support.\r\n\r\nThis revised piece remains fully compatible with the switch holder included in the original post.