powerhobbies XL whitewall wheel rings

thingiverse

Adding some flavor to my xmaxx with power hobby XL wheels. these will need to be glued onto the wheels. 2 versions, a wide whitewall (shown) that does go into the center of the wheel past the lip of the wheel, and a narrow version that is even with that lip. I usually use ic-2000 rubber CA to glue them on, so it flexes a little bit. I have tested many wheel rings in pla+ and in TPU, both work fine (TPU shown). but I suggest TPU if you are a hardcore basher, because you'd be surprised how much your wheels actually flex on a landing from 50ft up. You could probably hot glue or E6000 these on and be fine if you use a quality glue, which would give you more flexability, especially if printed in tpu.