PowerCon Power Distributor

prusaprinters

<p>Was in need of a PowerCon power distributor for supplying some lights on a small stage (overhead). Insted of buying I just created this one.</p><p>I added a mouting position for half couplers (M10-Screw) that is separated from the power wires but with a hole to wire PE to the screw. Also I use some other diy distributors for stage floor operation with a switchable index-light so I added this here as well (20mm round snap in place). I can recommend double end sleeves with 9 cm of wire between the SchuKo-sockets (standard 50x50 mm sockets).</p><p>PowerCon and switch are wired with 4,8 mm Faston (shielded). For the index light and PE connection for the coupler I recommend Wago connectors.</p><p>Screws used:&nbsp;</p><ul><li>16 M4x16 for the SchuKo sockets</li><li>4 M3x10 for the PowerCon sockets</li><li>8 M3x12 to close up</li></ul>