
Powerbox Systems Core/Atom Slider and Knobs for hand- and tray-version
prusaprinters
A new slider and Knob for all Powerbox Core/Atom transmitters. This slider ensures more clearance for the buttons on the top edges and brings a new ergonomic approach to this transmitter series. ASA Settings: 0,25mm Nozzle, 260°C Nozzle, 110°C Bed, 0,15mm Layer, 5 Perimeters (important to give more strenght to mounting holes!!!!), 50% infill, object cooling always on (start at layer 0) to prevent elephant foot, all supports on, brim off. I use Fiberlogy ASA, that stuff works awesome with the predefined filament profile in Prusa Slizer. Any other ASA or PETG might work as well. Printing direction and useful advice: I used to print on the mount hole attached to the surface of the print bed with all supports enabled. It depends on your filament and your printer settings how this slider will fit, the measurements of the mounting hole are nice and tight to the transmitter pin. If your filament was a little bit too fluid or your cooling insufficient, use a cutter blade to remove the elephant foot inside of the mounting hole carefully. I added a small round edge on top of the mounting hole to support a better installation and hope this prevents all I wrote here before. Use the screw to get this slider finally in place. For uninstallation use a soft microfibre cloth, wrap it over the slider area and pull gently to remove. Update V2.0:Increased distance to TX housing Increased pad dimensions for better fingertip support.Increased height to 28mm.Mounting hole optimized.New part depth for srew head.A special version for tray transmitters only. Update V2.1:Fixed mounting measurements for transmitter pin. Use a cutter blade to clean the mounting hole after printing if necessary! Update V3 Slider / V2 Knob Optimized for easier printingReworked the Slider handle Update V4Better measurementsFixed travel issue of tray-only version Update V5 (tray version only)Optimized travel Update V6 (tray version only)Fingertip support for top and side use
With this file you will be able to print Powerbox Systems Core/Atom Slider and Knobs for hand- and tray-version with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Powerbox Systems Core/Atom Slider and Knobs for hand- and tray-version.