Powerade Waterfall Bong

cults3d

With this file you can make your own waterfall bong! This 3d printed cap takes a 14mm glass bowl. Simply poke a small hole near the bottom of your powerade bottle, add water to your bottle while holding your finger over the hole you just made to keep the water inside then screw on the 3d printed cap. Insert your glass bowl and fire it up! once lit remove your finger and let the water flow out of the bottle. The suction will draw in the smoke which then can be inhaled once you remove the glass bowl. It's best to use this bong outdoors or over a sink if indoors to avoid a mess. Prints very easy with no supports. 0.3 layer height is fine and i used 40% infill to help give a nice air tight seal. Enjoy!