Power switch mount

thingiverse

This is a simple mount designed for attaching a power switch to a Prusa. The STL settings are for a 18.5mm hole rocker switch from Radio Shack, on a 5mm thick plate. The printer may print it slightly wide, but the nut on the back of the switch can still screw down flush to the end of the switch. The design is sliced with 3 perimeters and 25% infill, requiring no support. The power switch is connected to the power enable pins on the PSU for toggling power on and off. It was derived from the end stop thing as a starting point in OpenSCAD for learning purposes. However, it has not been tested for much variation.