Power supply w offset power cord mount bracket (for DC variable speed pumps) 2.3 x 1.25 x 5.25+

prusaprinters

designed to hold the 2.3x1.25 ac to dc power bricks common to computers & other electronics.Offset plug space on bottom of bracket (possible able to hold center mount plugs if inserted power cord end up - YMMV)Made the bracket well ventilated since it will already be in a weathertight demarcation case used to control pond & hothouse devices.I went for a balance of passive ventilation & solid support.Intended for use with hex drive miter head M3 machine screws.Also wall mountable using #6 miter head wood screws.Printed on my taz4 60c bed, 205c hot end using 2.85 matt black polymaker PLA.Printer was set for 85% feed rate.Orient upright with offset port on printer baseplate.gcode output (in zip file) Taz cura set for fast, 2 wall, 3 face, 10% infill with short side slice termination.  I recommend you set to fine, with 90% feedrateI printed 2 at once, took about 5.5 hours on fast, only slightly less time printing just 1.On fine print on taz4 would be over 7 hours.I was able to print without supports with minimal crudding on fast print, fine should print very cleanly without supports.