Power Supply Terminal Shield for Meanwell LRS Series

thingiverse

This is a shield to help prevent the terminals from being touched on a Meanwell LRS form factor power supply. I'm using it on an LRS 200-24 but it should work on any supply that has the 30mm tall X 115mm width form factor. Due to the low profile of this class of power supply, the usual method of screwing the shield into the side rails of the power supply doesn't work very well. So, I designed this shield to snap into place without the need for any fasteners. A pair of finger posts allows you to spread the pins that hold the shield in place. Printing: I used PETG because it has the right amount of "springyness" to operate the finger posts and spread the pins for install and removal. Other materials such as PLA and ABS may work as well. Use support. I printed with four walls and 20% infill but those are not critical values.