Power supply mounting base

thingiverse

I needed to get my workspace in order so that those power supplies weren't just dangling around everywhere. Also, I wanted to stop those power supplies from sucking phantom power when they weren't in use, so I installed a power switch to control both of them. The power switch and receptacle were salvaged from a dead computer power supply. Their dimensions are probably similar to many other power supplies. The power switch is mounted on the front side of my printer for easy/quick access. I ended up cutting off the original power cord to the UM power brick because I didn't have any extra plugs. I used my previous hinged bracket design to stow those power supplies under my printer: http://www.thingiverse.com/thing:679363 Also, my heater relay got fried , so I replaced it with a FET as suggested by JonnyBischof here: https://www.youmagine.com/designs/ultimaker-heated-bed-mosfet-relay-hack-v2 The relay board is attached to the side wall of my printer using a special standoff set (scad and STL included here).