Power Supply Covers

cults3d

I use a 24V 240W power supply from Singpad, covering it with a switched C14 power inlet. I'm not sure if this setup also fits the 12V 360W version of the power supply. The screw holes in the plastic are designed to be tapped with an M3 tap. If you use a screw for tapping, do so carefully to avoid damaging the part. Insulated female spade connectors with a diameter of 0.187 inches and rated for 22-16 gauge or 14-16 gauge wire may be useful when wiring the switch. The power inlets don't come equipped with a fuse, but you will likely need a 250V fast blow fuse measuring 5mm by 20mm if you're using this setup with a 3D printer. The current rating in amps will depend on the specific printer being used. For help with wiring or fuse selection, check out this post. Printer: Eustathios Filaments: eSun Blue PLA