Power Supply Cover for S-360-12 360w PSU by HodgerTech

thingiverse

I designed a power supply cover for my S-360-12 (360 watt 12 volt 30 amp DC Universal Regulated Switching Power Supply) when I couldn't find one that fit my needs. The cover features an IEC plug, fuse, and switch for easy modulation of the power supply, providing a safe and reliable source of power to your 3D printer. It also has a modular mount on the side to hold any additional accessories required. Plenty of vent holes prevent overheating of the PSU. Enjoy! Video: https://www.youtube.com/watch?v=okaEBJUFsfo Print Settings: Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: .1-.4mm Infill: 20-40% works best Notes: The print should be a 2 out of 10 for hardness to print, very easy and doesn't require support material since I designed it with the intention of being 3D printed. Post-Printing: Remove your bed, and you're good to go! It's best to put screws in before placing the IEC plug unit on the PSU to "self-thread" the holes. Avoid over-tightening as this may strip your holes. If that happens, use a screw that goes past the mount section and secure it with a nut!