Pouring Aid for plants - Small and Medium

prusaprinters

<p>So my gf needed a pouring aid for watering her tiny and medium sized plants, because she always kept on pouring water on the table and not into the actual planter, just because of the tiny sizes of the pots, and because a lot of these tiny plants like to cover the whole ground.<br/> Also she wanted something so the water doesnt stay on top (and probably also spill/run out of the planter), but rather flows right to the roots of the plant.</p> <p>Also it should be a bit prettier than the things she found on amazon.</p> <p>Given this instructions, i designed this in fusion 360 from scratch, using the "Loft Feature" and this awesome video from makers muse:<br/> <figure class="media"> <oembed url="https://www.youtube.com/watch?v=4UVEDKz2c5w"></oembed> </figure> </p> <p>Prints in vasemode! The small one takes about 25mins to print @60mm/s, the medium sized around 1h 10mins.</p> <p>Just stick this into the plantpot, and make sure the head is somewhat reachable, and you should be good to go. Oh, and also, still pour in the water slowly, as the reservoir on top isnt that big, and you should stick it all the way in, and then pull it out a bit to make a tiny cave, where the water can vanish quicker into the surrounding soil.</p> <h3>Print instructions</h3><h3>Category: Outdoor &amp; Garden Print Settings</h3> <p><strong>Printer Brand:</strong> TEVO</p> <p><strong>Printer:</strong> <a href="http://amzn.to/2BZ2yKm">Tornado</a></p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.3</p> <p><strong>Infill:</strong> 0%</p> <p><strong>Filament:</strong> Owl Filament PLA a lot<br/> <strong>Notes:</strong></p> <p>PRINT IN VASEMODE (CORKSCREW MODE) !!!<br/> With no top or bottom layers!</p> <h3> How I Designed This</h3> <p><strong>Designed this in fusion 360, so i can change all scales and shapes, and just reexport for a new/different pouring aid!</strong></p>