Pour Over Coffee Stand - Prints without support

thingiverse

I looked at stands that are pre-made and thought they were too pricey for what you get, plus most of them need support or are made with a lot of plastic, so I decided to make my own stand that prints without support and uses the least amount of filament necessary. When placed on its back all overhangs are at 45 degrees, so if your printer can handle this angle you should be able to print this stand with ease. Again, it's essential to print this stand lying down, otherwise you'll need some sort of support. I included a version with mouse ears that help keep the corners in place, they're 0.4mm thick and can be cut off after printing is finished. Alternatively, if you have issues with adhesion on larger prints, you could use a brim instead. I used PETG for this but ABS would also work well. I'm unsure about PLA since brewing coffee involves high heat, maybe you could try printing one with PLA and then anneal it? My Hario V60 knock off fits perfectly in the square at the top of the stand, which measures 70mm x 70mm.