POTTERMORE WAND 1 - HARRY POTTER 3D print model

cgtrader

This is my latest Wand design 1! Inspired directly from the magical world of Harry Potter! I designed and modeled it all by myself! Modeling took precisely 1 hours. The model features crisp, high-resolution details. This particular wand is crafted in two parts for optimal customization and control. In order to bring it to life, you will need to use Cinema 4D. NO support material is required, simply print as usual! Don't worry about preparation time – this design prints perfectly without requiring any additional handling. A layer height of 100 micron (0.1mm) should be enough; if so, feel free to skip sandpaper altogether! RELEVANT CR-10 PRINT SETTINGS FOR MAXIMUM PRECISION: * A reliable printing success at 100micron (0.1mm) Layer Height is achieved. * Use %50 infill settings for optimal density. * Since no support material will be needed, NO SUPPORT IS REQUIRED AT ANY POINT. To achieve best possible results: Set your Bed Heat to a warm but gentle level - just 60 degrees would suffice; also keep the nozzle temperature consistent with your normal practices, which ideally sit around 200 degrees. You're looking at approximately 5 hours of uninterrupted printing time! That's my Wand design number 1 in all its details - if it gets any love or attention out there from potential fans: thanks! Don't hesitate and follow my artistic pages for what’s next. Visit these Instagram handles @tolgaaxu, or simply hop over to @buyucusokagi