pot à planter Accessories

prusaprinters

<p>These are some accessories I made for for Senior55's seed sprouting planter.</p> <p>Their planter can be found here: <a href="https://www.thingiverse.com/thing:4811858">https://www.thingiverse.com/thing:4811858</a></p> <p>Included:</p> <ul> <li>A greenhouse cap for the planter -this will make it so the sprouts need to be watered much less often. It will also greatly increase your success rate for rooting cuttings.</li> <li>A basket for lifting sprouted plants out of the planter as they mature (this is my third revision -I made it a bit more sturdy &amp; easier to print</li> </ul> <p>Greenhouse Cap assembly instructions:</p> <ol> <li>Supplies needed: All 6 parts with "Planter Cap" in their name printed; Super Glue; A sheet of plastic wrap</li> <li>Press-fit the pieces together while setting the "Planter Cap B" piece to the side for now (should be pretty straight forward) -I recommend a drop of superglue for each press fit joining</li> <li>Fold a sheet of plastic wrap (cling wrap) onto itself so it forms a 2-layer thick square</li> <li>loosely drape your plastic wrap square over your assembled frame</li> <li>pick up the "Planter Cap Frame B" that your previously set aside &amp; slide it down over the plastic wrap &amp; assembled frame -This should also pull the plastic wrap taught</li> <li>Snap the "Planter Cap Frame B" into place over the assembled cap. This should secure the plastic wrap in place by sandwiching it between the two frame sections.</li> </ol> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> </p> Category: Outdoor & Garden