Pot handle for 25 cm pot

thingiverse

Print the pot handle horizontally without support to make it stronger, or vertically with support and wide brim if you have problem with printout deformations. The holes for the screw and the screwdriver may need to be drilled to correct them. Do not print with PLA or PETG, they soften significantly at the temp. of boiling water! Use ABS at min. 260 deg. C without printout cooling to make it stronger! After installing the printed handle, test the pot by filling it with cold water and lifting the pot. The author does not accept any responsibility for the accidents, injuries, burns, property loss caused by the failure of the handles. It is your responsibility to make strong handles and to properly install and test them! This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/0i6e6HV9wZ1 Ungroup first to change the pot size, then move the pot cylinder to create a recess in the base of the handle.