Portal Turret Pumpkin

thingiverse

I see you... Print these parts to build yourself a Portal Turret pumpkin. Find a fairly narrow pumpkin and you're good to go. For this, you will need to print one of each item except for the front leg and the leg cap, which require two of each. In addition to the 3D printed parts, you'll also need six red 5mm round LEDs. <h1>Print Settings</h1> <h2>Base</h2> Orientation: Flat down Infill: 20-30% Layer Height: 100-200 microns Support: None <h2>Right & Left Turrets</h2> Orientation: Guns facing up Infill: 20% Layer Height: 100-200 microns Support: From Build Plate <h2>Middle</h2> Orientation: Holes facing up Infill: 15-20% Layer Height: 100-200 microns Support: From Build Plate <h2>Front Leg</h2> Orientation: On its side Infill: 30-45% Layer Height: 100-200 microns Support: None <h2>Back Leg</h2> Orientation: Vertical Infill: 30-45% Layer Height: 100-200 microns Support: None <h2>LED Eye</h2> Orientation: Flat down Infill: 25-30% Layer Height: 100 microns Support: None <h2>Lens</h2> Orientation: Flat down Layer Height: 100 microns or less Infill: Top Solid Layers: 4 Bottom Solid Layers: 4 Support: None Material: Print in an opaque black filament. It will be slightly translucent and diffuse the LEDs slightly. <h2>Leg Cap</h2> Orientation: Groove face down (Flat side face up) Layer Height: 100 microns Infill: 20% Support: From Build Plate