PORTAL GUN (no screw needed)

thingiverse

Portal gun remix, I sliced it and made studs to make it easy to print big. Everything assemble you will only need a little glue to hold everything in place. For the handle part, the supports are a nightmare to take off so be carefull with your settings and make them light. Print 1 of each pieces with the exeptions of 3 CLAWS and multiple STUDS (I always print more than needed if some fails) For the light and tube I used an old light bar of a scanner but you can use whatever you want there is enough room in it to fit an arduino or something like it. And for the clear tube I cutted a clear plastic bottle (I used a bottle of SCHWEPPES Agrum for min because it's flat) For the cables I used old cables found in the trash, and I used a small thermic printer for the logos on the sides. The size I made it is not 1:1 accurate it's a little smaller but enough for display or a cosplay. You can still make it bigger if you can or modify it. And remember : -Do not touch the operational end of The Device. -Do not look directly at the operational end of The Device. -Do not submerge The Device in liquid, even partially. -Most importantly, under no circumstances should you [bzzzpt]