Portable soldering Station for KSGER STM32 OLED V2.01 T12

prusaprinters

<p>I needed a portable case for my soldering station do solder LED stripes on the go.<br/> I had a controller laying around and some 3S LiPos, so I came up with this design.</p> <p>You will need:</p> <ul> <li>KSGER STM32 OLED V2.01 Temperature Controller (AliExpress: <a href="https://bit.ly/3o0YU6r">https://bit.ly/3o0YU6r</a>)</li> <li>3S LiPo 11.1V/30C/3000mAh (I have this one from Gearbest: <a href="https://bit.ly/33i7shq">https://bit.ly/33i7shq</a>)<br/> ---&gt; Check the physical dimension of the LiPo!</li> <li>XT60 Connector, Male (AliExpress: <a href="https://bit.ly/3fFtmA5">https://bit.ly/3fFtmA5</a>)</li> <li>On/Off switch 15 mm*10 mm (AliExpress: <a href="https://bit.ly/3q5BJtH">https://bit.ly/3q5BJtH</a>)</li> <li>Some wires</li> <li><p>7 M3*30 mm screws To use it completely</p> </li> <li><p>T12 Handle (AliExpress: <a href="https://bit.ly/379PiQg">https://bit.ly/379PiQg</a>)</p> </li> <li><p>T12 Tips (AliExpress: <a href="https://bit.ly/33lPRoG">https://bit.ly/33lPRoG</a>) I printed the middle part upside down, to have the ugly support interface side hidden in the inside.</p> <h3>Print Settings</h3> </li> </ul> <p><strong>Printer Brand:</strong></p> <p>Ultimaker</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ultimaker 3 Extended</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div><strong>Resolution:</strong></p> <p>0,2</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>25%</p></div></p> </p></p></p> Category: Tools