Portable Nintendo Switch Adjustable Holder

thingiverse

I designed this Nintendo Switch mount because I needed something lightweight and portable for travel. While other designs meet these requirements, they didn't quite fit my vision. The attached photos showcase the part printed at a 0.1mm layer height, moving at 60mm/s, with zero infill and ten percent support structures using eight millimeter brim. To achieve optimal results, use support for both components. Print the base flat on its surface as you would typically utilize it. Conversely, print the top piece in an upright position. All that remains to complete this mount is two M3x15mm bolts and two M3 nuts.