Pool Accesory Holder for Deck Pole (skimmer nets and poles)

prusaprinters

This pool pole holder is meant to help you organize pool pole based accessories vertically on a deck pole. It has spaced out holders for 3 poles and fits tightly to a deck pole.Note Before Printing: Please measure your deck post and pole accessories' diameter before printing.   Leave a comment if your measurements are different to the two below, and give me about a week to add a model to fitting your needs.  These are the two current models is made for:Deck pool with a width of 3.5" and accessory pole diameter of 1.25", andDeck pool with a width of 3.5" and accessory pole diameter of 1.00". Printing:The only test I've done was with PETG and 8 walls.  This generated a solid model.  PETG is flexible enough that even with a solid model, the pool accessory poles snap really well.  If you use a more rigid material such as ASA, you may have to use less walls (maybe 4) to allow flexibility (please let me know your results).No supports are needed if printed in the original STL configuration.  PETG with PEI plate didn't necessitate brims either.Mounting:I mounted mine by flipping the print head-to-toes, but this is your preference.  Structurally, I think the way I mounted it makes a bit more sense.  This also allows a hard stop for the accessories.I used all 8 screws (8 holes) and used the shortest wood screw I had (1").  You might get away with just 4 screws (one on each side and two on the front).