Polycarbonate square support 3mm

thingiverse

Straight L-shaped supports for 3mm thick polycarbonate are quick to install and remove. The enclosure helps maintain temperature, resulting in improved 3D printing with ABS. Considerations: A programmed zigzag support generates too much material and leaves the surface rough. Instead, program a less dense support for a smoother finish. CUra Configuration: Layer height: 0.2mm Initial layer line width: 100% Wall thickness, upper, and lower bases: 1.2 mm Fill percentage: 30% Printing temperature: 200 degrees Celsius Hot bed temperature: 60 degrees Celsius Flow rate: 100% Print speed: 60mm/s Filling speed: 60mm/s Wall speed and initial layer speed: 30mm/s Retraction enabled Retraction distance: 5 mm Retraction speed: 60 mm/s Refrigeration activated at 100% Supports set to zigzag.