Poltur XL 300x200mm Heatbed add-on

thingiverse

This design is created to add a purpose-built low-cost 300mm wide heated build platform to my Poltur XL printer design. This design utilizes 2x 600mm x 8mm linear round rails and bearings, available at http://www.banggood.com/200600800mm-x-8mm-linear-rail-shaft-rod-with-bearing-guide-support-and-scs8uu-bearing-block-p-1104573.html?rmmds. Additionally, it requires 1x 200 x 200 12v silicone heat bed mat, available at http://www.banggood.com/12V-200W-200mmx200mm-waterproof-flexible-silicone-heating-pad-heater-for-3d-printer-heat-bed-p-1123501.html?rmmds. The design also includes 2x 300 x 200mm Aluminium plates, available at http://www.ebay.co.uk/itm/111379898202?_trksid=p2057872.m2749.l2649&var=410361283870&ssPageName=STRK%3AMEBIDX%3AIT. All printed parts are detailed in this thing, and all electronics remain the originals used in the PrintRite DIY, which was the original donor printer. Printer Settings: Printer: Poltur XL Rafts: No Supports: No Resolution: 0.3 Infill: 30% Notes: The extruder mount displayed in the above pictures is a modification to allow an MK8/MK7 extruder to utilize the entire 300mm width of the build area and is designed for use with my latest X-axis modification, both can be found here... http://www.thingiverse.com/thing:2122112. This thing can also be used with the original X-axis design (typical I3 type axis).