Poltergust G00

myminifactory

My kid begged for a Luigi's Mansion costume this Halloween, so I set out to design a Poltergust replica that would make them proud. After crunching numbers, the total weight comes in at 2.2kg, which could translate to around 60 hours of print time depending on your settings and infill preferences. If you're keen on printing specific colors for certain parts like I did, be prepared to use approximately 1.2kg of red, 400g of black, 300g of green, 200g of grey, and a dash of clear PETG (about 100g). To make things easier for you, the STLs are carefully labeled and color-coded. The main body consists of three sections, built with four walls, five top-and-bottom layers, and a 7% infill to keep it as lightweight as possible. The alignment pins are all set up on a raft and ready to go – just print them out! However, you'll need to add some support for the bottom/mid main body, but the top half will require supports only where it touches the build plate or model.