Polishing Foam Pad 125mm Dispenser (wall mount)

thingiverse

Variations of Dispensers for 125mm polishing pads. (125mm backing plate, 145mm largest diameter) Pad dimesion like in the picture. Can be mounted on the wall with two screws if needed. I will try to explaint the different variations: For each part there is a "stable" and a "ergo" version: In the "stable" there is a connection between the side walls, because i am not shure how stable it is without the connection. But with the connection it is harder to put the pad in and out. That is why there is also a "ergo" version, without connection for easy filling and unfilling. Two Versions of Part1 (each with ergo and stable) with open and closed end. The open part is compatible with Part2 for extension, where the clodes part (...end) is not extendable. Same thing for part2, there is a open und a closed ("end") version. Part3 is only open, you can extend as far as you want. Also part3 is compatible with "part1_open", but optical not fitting. Part2 and part3 "ergo" are almost the same, just a difference in the height: part2 240mm, part3 220mm. But you can make those smaller by offsetting in the slicer. Feel free to mix the versions. Maybe stable base (part1_stable_open) with ergo part2 open or end is a good compromise. You can also stack a few part1 for more openings and seperations. Maybe cut a additional opening. There is no special fixation between the parts, i would suggest a tape on two sides of the wall. Inclines are at least 60°, supports needed for the "mouth" at the bottom Wall thickness 3,2mm Still work in progress, not printed yet. Maybe a few optimizations coming. Thinking about a smaller opening (not so wide) and a bigger Grip cutout. Maybe i will reduce the wall thickness for the stable verison. Feel free to comment. I am happy with any suggestion or feedback.