Polestar 2 sunglasses holder

cults3d

The Polestar 2 doesn't have any good location to store sunglasses in my opinion, at least not unless you also keep them in a case/cover to protect them (allowing for storage in door bins or center console pockets). So I decided to fix that, and I found what I would consider a nice solution. In the ceiling, there is a protrusion in the headliner where the logo projector is. This is a good location to keep sunglasses, easy to reach and very accessible. So to be able to use this location, I created a custom holder which simply clips onto the edge of the headliner, which then holds the sunglasses in a horizontal position with the lenses pointing up towards the glass roof. To take the glasses down from the holder is simply a matter of grabbing them by the temples/arms and lifting them up and over the "nose" of the holder. No chance of getting finger smudges on the lenses. The holder should be fairly universal, and I have tested a number of different pairs of sunglasses (and prescription glasses too), but I am certain there will be some that doesn't fit, so no explicit guarantee of fit can be given. It is also possible to add a thin layer of double sided sticky tape to the inside upper lip of the holder for additional holding strength. In 3D printing there will always be varying tolerances, so the end result will differ a little from printer to printer. Note that it has been designed to fit in the center of the protrusion, if clipped on towards one of the sides, it will probably not work as well. Video showing how to use: https://www.youtube.com/watch?v=UfC6wq6Qai8