Pokemon Go Plus Back Cover Replacement to use with Apple Watch Lugs

prusaprinters

<h3> ---Update 9-26-2018---</h3> <p>V3 shrinks the insert area and adjusts the screw hole. original screw hole does not allow the screw to reach the go plus thread.</p> <p>The original insert area in v1,v2 was too large and the waterproofing would be useless before.</p> <h3> ----Update 9-2-2018----</h3> <p>V2 Adds more material around the problem areas that were too thin and were actually critical in holding the lugs</p> <h3> --Original Description--</h3> <p>I personally haven't printed this thing yet. But By the amount of overhangs and thin sections, it might be best to print with a really good printer that may not need supports or a laser based printer.</p> <p>This is designed for use with the Apple watch bands. But in my case, I plan to use some Apple Watch Lugs that are adapters for 22mm watch bands.</p> <p>The latch that gets pushed into the groove is releasable by a small, less than 1mm, pin hole found at the bottom side of each of the lug profiles</p> <p>I used Solidworks 2017<br/> Leave a comment asking for it and I will send you a link to the part file.</p> Category: Video Games