Pokeball Switch Cartridge Holder

thingiverse

Watch my video for assembly at https://youtu.be/RdnuUNqGxY4. The spring I used is from a cheap Pokeball that you can buy online for a few dollars, and it's actually quite effective. Some 1.75mm filament works well as a hinge that you can open manually by hand, but if you want to do that, you may need to drill or melt a slightly larger hole. The holes where the wire goes in for the button may not print properly because they're so small, so you might need to drill or heat up a pin to poke through them instead. I printed mine with automatic supports enabled. If you do the same, make sure to remove any small pieces of plastic from the inside parts where the button clicks into place, as they can be easily missed if you don't. If not, the button might become too sensitive to press.