Pokeball Switch Cartridge Case

cults3d

Please check out my video for assembly instructions https://youtu.be/RdnuUNqGxY4 Remixed from https://www.thingiverse.com/thing:645246 I built a Pokeball stand based on thingiverse.com/thing:411193. The spring release I used came from a cheap Poké Ball that you can buy online for just a few dollars. You can also use 1.75mm filament as a hinge that can be opened manually by hand. However, if you want to do this, you may need to drill or melt the filament slightly to make it bigger. The holes where the wire goes into the button might not print properly due to their fine size, so you'll likely need to drill or heat up a pin to puncture these holes instead. I printed my stand with auto supports. If you do the same, be sure to remove any small pieces from the upper and lower inside parts where the button clicks into place as they can easily get missed. If not, the button may become too sensitive.