Pokeball Stand for Ultra Swole Pikachu

thingiverse

Updated: I've uploaded the completed base that I used in my finished model as seen in the new photo. The original SS Pika model is too tall for my original stand to function properly.\r\n\r\nI love this Pikachu model by Cyenyee, but its base was almost unprintable due to weird unnecessary cavities and bridges. So, I had the idea to create a stand shaped like a pokeball that's weighted at the bottom, allowing it to wobble but not fall over.\r\n\r\nUnfortunately, it only halfway works as intended. If you print out just the top piece, you can use it as a stand, but I positioned Pikachu off-center on the ball, causing it to flop over.\r\n\r\nFor now, you can print off just the top piece and use it as a fixed stand, but the whole stand (top and bottom) will need to be reprinted once I make some necessary adjustments.