Pokeball ashtray for IQOS

thingiverse

I call it the "Ash" tray because of what I did there? The kid is 10 years old, but he's been stuck in this age for about two decades - I'm sure he's a smoker by now. This design was inspired by the planter here: https://www.thingiverse.com/thing:2239205 Notes: 1. You should turn on supports for printing the lid (90-degree angles only). If you're using a glass bed, you can probably print without supports by placing the lid upside down. I don't have a glass bed, so I printed with supports. 2. Every other part doesn't need support. 3. The button is a small part, so for it to look and feel better, I printed it with 100% infill (you can drop this value depending on your printer). 4. 20% infill is more than enough for every other part. 5. When printing the middle part, I found that it looks better if you align the button hole on the Y axis - this will eliminate the ghosting. 6. Every part fits and sits tight, but you'll probably want to sand the button a little bit to put it in place.