Pogo Pin Protector

thingiverse

As an accessory to the AVR ISP Pogo Adaptor Kit, I designed a tiny pogo pin guard to prevent the pins from becoming bent. The tolerances are pretty tight, so I had to drill out the pin holes with a 1.5mm flathead screwdriver tip to ensure everything would line up perfectly. Note: depending on how flush your pogo pins are, you may need to modify the `pin_height` variable in OpenSCAD. Ideally, you should measure from the board along the pin to the center of the pin head. The pins must be able to spring into action to make good contact, but the pin head should not protrude from the protector. See this on Github