Poe injector for network switch

Poe injector for network switch

thingiverse

This device is specifically designed for powering IP cameras (12V) over a Cat5 Ethernet LAN cable. It is intended for use in locations where the LAN cable has a maximum length of 20-30 meters. The device supports up to 4-5 cameras, but can be upgraded as needed. To power it, you will need a 12-volt, 3-4 amp power supply, a 5-port 100Mbps/Gbps switch, and a 12V to 9V (7V) step-down module with 1 amp capacity. The Gerber file and Fusion360 files are also required for assembly. The device uses the 12-volt power from the supply connected to the POE injector. The first four connectors provide power transfer to the cameras via two pairs of LAN cable wires (Blue + and Brown -). The remaining wires are used for data transfer. From the fifth connector, the 12V is stepped down to 7-9 volts to power the network switch. If the network switch is powered by a separate supply, you can use the fifth port to power a fifth camera.

Download Model from thingiverse

With this file you will be able to print Poe injector for network switch with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Poe injector for network switch.