pocket wallet

thingiverse

I designed a convenient pocket wallet. In V05, which is an update from 25.05.2020, several improvements were made: - The upper and lower edges are curved up - The cut-out is larger for easier grabbing of credit cards - It's optimized to remove the bottom more easily - The movable part was optimized for greater durability - Now works fine with PETG too - No supports are required anymore. (It was tested with materials PLA, PETG and also Polyflex.) After printing (and removing support material) you should push the movable part away from the Bottom, because it may stick a little. Use a screwdriver and push it through the holes in the bottom of the part. Start with the farthest hole from the slider. Important print settings: - Supports only to the printing bed (only for old version needed) https://www.youtube.com/watch?v=HUi8NG4hDPE