Pocket Operator Case

prusaprinters

<p>Case for Teenage Engineering's Pocket Operator. This case is compatible with the wire folding stand, and the loop at the top doesn't need to be removed. All LEDs shine through a small hole above each button, and there is a hole to allow the use of the microphone on the 3 series POs.</p> <p>I wouldn't say that protection and strength were a priority for this design but I think it looks about as good as some of the other cases I have seen for sale. Keep that in mind if you're looking for something to protect your POs on your Everest climb, or Antarctic expedition.</p> <h3>Print instructions</h3><p>Printed on my MK3 i3 using the Quality settings at 0.2mm layer height using Filaments.ca Ecotough PLA. No supports needed and I printed without a brim, but maybe you prefer to use a brim, it probably doesn't make much difference. You need to print out 23 of the buttons, per Pocket Operator. Print the buttons in a different colour so it looks snazzier.</p>