Pocket box

thingiverse

Small pocket-sized box with rounded edges and button closure. Maximum opening 120º. Print the two halves with 0.4 mm or less of layer height. Being flat pieces of a certain size, it's necessary to have good adhesion to the bed to avoid warping. A hairspray on the glass is not enough. Print the two pieces of the closing mechanism with 0.1 mm of layer height. Depending on the accuracy of the printer, you may need to check the two parts of the closure, the hooks on top and the hinges knuckles with a watchmaker file until everything fits and slides correctly. Glue the largest part of the lock into the corresponding hole in the bottom part box. If you have printed in ABS, use PVC cement. Once dry, place the spring and the opening button, and put a 0.6 mm diameter wire pin in the part of the button protruding into the inside of the box. Put a 0.7 mm diameter wire as a hinge pin. Print Settings Printer Brand: Prusa Printer: Prusa Steel Rafts: No Supports: Yes Resolution: 0.4 mm hotend - 0.1-0.2 mm layer height Infill: 100% Notes: Use good adhesion method to the bed. The hairspray on the glass is not enough. How I Designed This FreeCad, Cura