Pneumy's Store: Peg Board Wall Mount

thingiverse

## Welcome to Pneumy's Store! (Free) _________________ This release is a wall mount to affix a peg board to a wall without having to drill into the wall! Simply apply double sided tape on one side, and press it up to the wall and it is good to go! Inspiration took from the absurd prices at the store for wall hangers, but here you get it free. If you like this or have comments then feel free to upload and ask them. I will probably not see them very often but I will check at least once a month. _______________ ### Note: _______________ The tip of the nipple is 7mm wide. This is made for the weaker stuff to be able to deform which ensures it will not slide off easily. It will take some force pushing it through, make sure you screw back and forth trying to push it through, and do not apply much force, it really isn't necessary. Below the tip of the nipple is 6mm for the 5.7mm board hole. These will set well as seen in images. Make sure you support the board when pressing. You will want quite a few. Update: If this is your only option you will need a lot of these. I would say around 20 are necessary if you plan on putting on a good amount of weight. I would not mount something like a drill on this though. _____________ ### Printing: ______________ You need some infill (I tried it without, it will just crumble). For me 15% did well, but feel free to try and adjust. Filament is anything you want. PLA works just fine. # Enjoy!