Plumbing Fittings Straw models

thingiverse

Plumbing fittings to be used with straws as the pipes are now available, offering models that simulate common PVC parts such as 2", 3" and 4". This innovative idea comes from Turtl3Sh3ll and expands on an original set of parts. The original set can be found here: https://www.thingiverse.com/thing:4240116 The straws used in these fittings are specified below: A 4-inch pipe with a diameter of approximately 0.41 inches (or 10mm) is needed, and it can be purchased from Amazon at this link: https://www.amazon.com/gp/product/B00B9HYSSS/ A 3-inch pipe with a diameter of approximately 0.31 inches (or 8mm) is also required, which can be found on Amazon here: https://www.amazon.com/gp/product/B07Z8B42K6 Lastly, a 2-inch pipe with a diameter of 0.21 inches (or 5.3mm) is necessary, and it can be purchased from Amazon at this link: https://www.amazon.com/gp/product/B07Z88RXZ5 Print Settings: The 3" and 4" models perform well when using layer heights up to 0.28mm. However, the 2" parts require a layer height of 0.20mm or less for optimal results. Supports: Yes, set at 75 degrees, with supports only touching the build plate. Plate Adhesion: None is required.