Plier_Holder_AU_Pegboard

thingiverse

Customized version of http://www.thingiverse.com/thing:537516 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=537516 Modified with 3.85mm pins to match 4mm peg board specifications. Print Settings: Printer Brand: MakerBot Printer: MakerBot Replicator 2 Rafts: No rafts used Supports: No supports were added Resolution: .2 resolution was chosen Infill: 70% infill density was selected Instructions: Using the following settings: Holder Height: Set to 25 units Number of Holders: One holder was specified Cutout Side: Zero point zero cutout side was applied Strength Factor: Sixty-six percent strength factor was used Holder Y Size: Twenty units were chosen for holder y size Taper Ratio: One hundred percent taper ratio was selected Holder X Size: Thirty-seven units were set for holder x size Angle of Holder: Zero degrees angle was specified Closed Bottom: No closed bottom was included Number of Holders Along Y Axis: One holder along y axis was chosen Offset from Edge: Zero point zero offset was applied Corner Radius: Five unit radius was used Wall Thickness: Two point eight five units were selected for wall thickness.