Playstation shaped coat hanger

thingiverse

For each hook you need to print 2 "barres" (bar. Well, half of a bar), 1 "fix" (to be screwed onto a wall or door), and 1 of the "triangle", "carre", "rond", "croix" part. The "fix" part can be printed without support (screw holes could be messy inside, but nothing visible). The two halves bars need support ("touching buildplate" in cura) ; the hook parts also need support ("everywhere" in cura) for the internal gap. Support is for nothing visible, only internal. So no need for lot of density here. Fix the part onto the wall first, and assembly later. Because, once it is assembled, it is quite hard to disassemble (you can do it, with pliers, tho), and once it is assembled, it is quite hard to access the screws. Then assemble the hook and the two halves bar, one at a time. Once you have inserted both, they should stick together, and remain in place. Then assembly the ensemble to the part you have already screwed onto the wall; push until you hear the "click". Note: you may want to downscale them a bit. Maybe 0.75 or even less. Once on the wall, they looked bigger than I expected (but, well, I didn't want to have heterogeneous sizes, and I didn't want to throw away what I'd already printed, so I kept them that way, and uploaded the model as I printed it)