Playstation PS3/4 Controller Stand Minimal

thingiverse

Check out my YouTube Channel, where new 3D printing videos are uploaded every week at http://www.YouTube.com/onlylittlemike. I needed to design a bracket that would be easy to print with low resolution while still holding my controller securely. Here's the result! To assemble, simply print two brackets per controller. If you encounter any issues, feel free to reach out. Instructions This design prints well at 300 microns resolution. A heated bed is not required, but setting it to 50c can produce satisfactory results. Printing at 100mm/s speed with three shells and a hex infill of 15-20% yields optimal outcomes!