PlayingStation 5 - Raspberry Pi Case

prusaprinters

<p>This is a Case for Raspberry Pi boards. Designed to work with a 28mm marine USB and/or HDMI extender, and a 12mm momentary 12vdc switch with LED, neither are required for use.</p><p>Uses 10mm magnets, and standard M3 hardware. Glue nuts in the nut traps, magnets in the magnet traps, and let dry for 1 day before use (or whatever you glue says). Make sure your magnets are facing the correct direction!</p><p>One side has an alignment peg that is first inserted, then swiveled into place, where its held in with screws. &nbsp;this side mounts the Pi also.</p><p>The opposing side mounts with magnets allowing for ease of accessing the Pi.</p><p>Cables can run through the caps between the middle and sides, or out one of the two rear 28mm holes.</p><p>The base gets screwed into the middle, this is easier to do before the side is screwed in.</p><p>The extender rings are there to give you a spacer if you need more room internally. just stretch the spacer to the height you need in your slicer. &nbsp;I think the space on the switch looks nicer than without, also. &nbsp;I updated the model to hold the pi at an angle after i had issues with cable strain. my pictures show the previous design and I only used 1 screw to hold it in, at the angle i changed the model to include. A fan is recommended, although there are inlets and outlets for convection flow.</p><p>The rhino (.3dm) file includes 2 decals on the Rpi board which significantly lower the viewport response, just FYI. use the BAKE command to eliminate the decals if viewport performance is an issue.</p><p>The AMAZING Pi4 model came from a fellow designer here: go like their stuff! - https://grabcad.com/library/raspberry-pi-4-model-b-1</p><p>I used this FANTASTIC PS5 model as a basis for checking my case proportions etc, go like their stuff too! - https://grabcad.com/library/playstation-5-3</p>