Platform Legs Adjustable

prusaprinters

I wanted a platform to raise my laptop so I can put stuff below it.I liked the design by ddude3548 because it was made for corners.I liked the design by unclerotten because it is adjustable with threaded feet.I didn't find any combination of them so I did them myself from the ground up but keeping the inspiration from these 2.With the foot fully threaded in there is a distance between the bottom of the platform and the desk of 12cm (or around there).There are a few extra cm of thread on the inside.I printed these in PETG to learn about it and it shows that they are an experiment.I didn't really measure to well the platform and I cut it a bit still too big (another thing to learn from).The leg also has 2 holes for screws in the board, they have 3mm diameter.I'm pretty happy with how they look, but I should have cut the board differently.Print SettingsPrinter Brand:CrealityPrinter: Ender 3 ProRafts:NoSupports: YesResolution:0.2 for the threaded foot / 0.24 for the big legInfill: 25% for the foot / 20% for the legFilament: PolyTerra PETG Black Notes: You can go lower with the infill (even to 15% maybe) , I used 3 outer walls on both parts to ensure sturdiness.The fit for the threads is pretty tight but manageable because I wanted little to no play. Use a lubricant if needed, I used Superlube.   Category: Office