Plastic Shelf Replacement Legs

thingiverse

I'm looking at a design that's not quite a remix. I had one similar project with eight spines instead of four, and I also needed replacement supports between the shelves. So here are some variations I came up with. The screw-together parts are actually quite strong. I printed these with various infills; the lowest being 20%. All of the legs need to be flipped 180 degrees for printing. Here's what I tried: 1. I flipped each leg 180 degrees, printed without supports, and used a 20% infill. 2. I printed two legs per unit, one screw for each corner, with an obvious connection at every corner. 3. I screwed the parts together to create a sturdy base. 4. And finally, I'm hoping to make a profit from this project!